CCNA Network Simulator Labs
NetSim
Network Simulator and Router Simulator provides labs designed to help you achieve the
CCNA certification. Each lab is written to help you understand the technologies necessary to pass the CCNA 640-802 exam. See the list below for all of the lab topics included with
NetSim for CCNA.
Lab Topics for CCNA 640-802
- Address Resolution Protocol (ARP)
- Advanced Extended Access Lists
- Advanced Router Configuration
- Backup Using TFTP
- Basic Debugging
- Basic Router Configuration
- Basic Show Commands
- CDP
- CHAP and RIP
- Cisco Discovery Protocol
- Cisco Discovery Protocol (CDP)
- Configuring IPv6
- Configuring Open Shortest Path First (OSPF)
- Configuring Router Interfaces
- Configuring Telnet on Catalyst 2950 Switches
- Configuring Trunking on Catalyst 2950 Switches
- Configuring VLANs on a Catalyst 2950 Switch
- Configuring VTP Client Mode on a Catalyst 2950 Switch
- Configuring VTP on Catalyst 2950 Switches
- Confirming the Network Configuration
- Creating a Host Table
- Default Routes
- Deleting VLANs on a Catalyst 2950 Switch
- Dynamic NAT
- EIGRP
- EIGRP and Wildcard Masks
- EIGRP Authentication
- EIGRP Routes
- Enhancing Switch Security
- Expanding Switched Networks
- Extended Access Lists
- Extended Access Lists with RIP
- Frame Relay
- Frame Relay Full Mesh
- Frame Relay Hub-and-Spoke
- IGRP
- IGRP Routes
- Implementing IPv6
- Implementing Network Address Translation Part I
- Implementing Network Address Translation Part II
- Initial Switch Configuration
- Inter-VLAN Routing
- IP Access Lists
- IP Addressing
- IP Addressing on Catalyst 2950 Switches
| - Loopback Interfaces
- Many-to-One NAT
- Named Access Lists
- NAT overloading - PAT
- NAT Pool
- OSPF
- OSPF Authentication
- OSPF Routes
- PPP and CHAP
- PPP with CHAP Authentication
- Review Basic Router Configuration
- Reviewing Access Lists
- Reviewing Switch Configurations
- RIP
- RIP Routes
- RIPv2
- RIPv2 Routes
- Router Basics I
- Router Basics II
- Router Remote Access via Telnet
- Routing Information Protocol (RIP)
- Saving Router Configurations
- Setting up a Serial Interface
- Spanning Tree
- Standard Access Lists
- Standard Access Lists with RIP
- Static NAT
- Static Network Address Translation (NAT)
- Static Routes
- Switch and Workstation Configuration
- Switch Basics Part I
- Switch Basics Part II
- Telnet
- Testing Connectivity with Traceroute
- Trivial File Transfer Protocol (TFTP)
- Troubleshooting EIGRP
- Troubleshooting Frame Relay
- Troubleshooting RIP
- Using Loopback Interfaces
- Using NetSim
- Using the Initial System Configuration Dialog
- Variable Length Subnet Masks (VLSM)
- Virtual Local Area Networks (VLANs)
- VTP
|