Special Offers | My Account | Log In
  0 items in your cart


Search: Boson Sites | Products
Sale
CCNP Labs

CCNP Network Simulator Labs

The NetSim 11 for CCNP Network Simulator, Router Simulator and Switch Simulator provides labs designed to help you achieve the CCNP certification. Each lab is written to help you understand the technologies necessary to pass the CCNP exam. See the list below for all of the labs included with NetSim 11 for CCNP.

NetSim 11 for CCNP Lab Topics

  • Address Optimization
  • Applying Security Tools
  • Backing up a WAN Connection with IPSec VPN
  • Backup Interface
  • BGP Path Selection
  • Configuring a Switch for a WLAN
  • Configuring Basic Border Gateway Protocol (BGP)
  • Configuring Class-Based Header Compression
  • Configuring EIGRP
  • Configuring EIGRP for IPv6
  • Configuring FIFO and WFQ Queuing Mechanisms
  • Configuring Frame Mode MPLS
  • Configuring Frame Relay
  • Configuring Integrated IS-IS
  • Configuring IOS Security Part I - VLAN ACL's
  • Configuring IOS Security Part II - TACACS+
  • Configuring IPSec
  • Configuring IPv6 Tunnels
  • Configuring ISDN BRI
  • Configuring LFI
  • Configuring Multi-Area OSPF
  • Configuring Multiple HSRP Groups
  • Configuring NBAR
  • Configuring QoS
  • Configuring QoS Preclassify
  • Configuring QoS with Cisco AutoQoS
  • Configuring Single-Area OSPF
  • Configuring Single Area OSPFv3
  • Configuring Support for IP Telephony
  • Configuring the LLQ Queuing Mechanism
  • DHCP Binding
  • DHCP on Switches
  • Dynamic Multipoint Virtual Private Network (DMVPN) Phase I
  • DMVPN Phase II
  • DMVPN Phase III
  • DMVPN with OSPF
  • DMVPN Security
  • EIGRP and Frame Relay
  • EIGRP Named Mode
  • EtherChannel Negotiation Protocols Part I: PAgP
  • Frame Relay with Dial Backup
  • GLBP I & II
  • Hierarchical IP Addressing
  • Hot Standby Router Protocol (HSRP) Authentication
  • Implementing Multiple Spanning Tree Protocol (MSTP)
  • Influence EIGRP Path Selection
  • Initial Configuration
  • Introduction to MQC and the SDM QoS Wizard
  • IOS Switching Initial Configuration
  • IPv6 Stateless Address Autoconfiguration (SLAAC)
  • ISDN Dialer Profiles
  • Layer 3 EtherChannel and Load Balancing
  • Layer 3 Switching
  • Layer 3 Switching and Layer 2 Security
  • Low Latency Queuing
  • Multi-Area OSPF and Routing Table Optimization
  • Multicast Routing
  • Multi-Site Frame Relay and Policy Routing
  • Multi-Site Network
  • Network Address Translation
  • Network Time Protocol (NTP) Security
  • Optimizing EIGRP
  • Optimizing EIGRP in Named Mode I
  • Optimizing EIGRP in Named Mode II
  • OSPF Special Area Types
  • Path Control I & II
  • Planning and Configuring OSPF Redistribution
  • Planning and Configuring OSPF Summarization
  • Policy Routing
  • PortFast and UplinkFast
  • Redistribution with Route Filtering
  • Route Redistribution
  • Route Summarization
  • Routing Information Protocol next-generation (RIPng)
  • Single-Site Network
  • Spanning Tree MST Configuration
  • Spanning Tree MST Optimization
  • Spanning Tree Protocol
  • Spanning Tree Protocol PVST Load Balancing
  • StackWise Basics
  • Stateful DHCPv6
  • Stateless DHCPv6
  • Troubleshooting Basic BGP
  • Troubleshooting Basic Frame Relay
  • Troubleshooting Basic Network Services II
  • Troubleshooting BGP
  • Troubleshooting DMVPN
  • Troubleshooting EIGRP Routing
  • Troubleshooting EIGRP Named Mode
  • Troubleshooting EtherChannel
  • Troubleshooting Hot Standby Router Protocol (HSRP)
  • Troubleshooting HSRP Authentication
  • Troubleshooting ISDN BRI
  • Troubleshooting MST
  • Troubleshooting Multilayer Switched Networks
  • Troubleshooting OSPF Adjacencies
  • Troubleshooting OSPF Areas
  • Troubleshooting OSPF Routing
  • Troubleshooting Path Control
  • Troubleshooting Route Filters
  • Troubleshooting Routing Protocols
  • Troubleshooting Spanning Tree
  • Troubleshooting Tickets 1-12 (12 Total Ticket Labs)
  • Troubleshooting VoIP and Converged Networks
  • Trunking
  • Tuning QoS Mechanisms Configured with Cisco AutoQoS
  • Using SDM to Configure GRE Tunnels over IPSec
  • VLAN Configuration
  • Virtual Router Redundancy Protocol (VRRP) Authentication
  • VTP Configuration

CCNA Level Labs Topics (included in NetSim 11 for CCNP)

  • AAA
  • AAA Login Authentication and Exec Authorization
  • Advanced Extended Access Lists
  • CHAP and RIP
  • Configuring a PPPoE Client
  • Configuring DNS II
  • Configuring Hot Standby Router Protocol
  • Configuring IPv6 ACLs
  • Configuring Multi-Area OSPFv3
  • Configuring Network Device Management
  • Configuring SSH
  • Configuring VRRP I
  • Configuring VRRP II
  • Configuring VTP Client Mode on Switches
  • Configuring VTP on Switches
  • EIGRP
  • EIGRP and Wildcard Masks
  • EIGRP Authentication I
  • EIGRP Routes
  • EIGRPv6 Configuration I
  • EIGRPv6 Configuration II
  • EtherChannel Negotiation Protocols: LACP
  • Expanding Switched Networks
  • Extended Access Lists with RIP
  • Extended ACL Practice Lab 1
  • Frame Relay Full Mesh
  • Frame Relay II
  • GRE Tunnels
  • HSRP Interface Tracking
  • InterVLAN Routing I
  • InterVLAN Routing II
  • IP Access Lists
  • Layer 2 EtherChannel
  • Multipoint Frame Relay I
  • Named Standard Access Lists
  • NetFlow
  • OSPF Authentication
  • OSPF Authentication II
  • OSPF Routes
  • Planning and Configuring Multi-Area OSPF I
  • Planning and Configuring Multi-Area OSPF II
  • Planning and Configuring Single-Area OSPF
  • PPP and CHAP
  • PPP with CHAP Authentication
  • Review Basic Router Configuration
  • Reviewing Access Lists
  • Reviewing Switching Configurations
  • Routing Information Protocol II
  • Spanning Tree I
  • Spanning Tree II
  • Spanning Tree III
  • Standard Access Lists with RIP
  • STP and MST
  • System Message Logging
  • Troubleshooting Access Lists
  • Troubleshooting ACLs 1 - Extended ACLs
  • Troubleshooting ACLs 2 - Standard ACLs
  • Troubleshooting ACLs 3 - Named ACLs
  • Troubleshooting EIGRP
  • Troubleshooting EIGRPv6
  • Troubleshooting EtherChannel
  • Troubleshooting Frame Relay
  • Troubleshooting Frame Relay II
  • Troubleshooting Hot Standby Router Protocol I
  • Troubleshooting Named ACLs
  • Troubleshooting OSPF
  • Troubleshooting OSPFv3
  • Troubleshooting Port Security
  • Using Loopback Interfaces
  • VLAN Leaking
  • VLANs
  • VTP
  • VTP Modes

  • CCENT Level Labs Topics (included in NetSim 11 for CCNP)

    • ACL Practice Lab 1 - Standard ACLs
    • ACL Practice Lab 2 - Standard ACLs
    • ACL Practice Lab 3 - Extended ACLs
    • ACL Practice Lab 4 - Extended ACLs
    • ACL Practice Lab 5 - Named ACLs
    • ACL Practice Lab 6 - Named ACLs
    • Address Resolution Protocol
    • Advanced Router Configuration
    • Backup Using TFTP
    • Basic Debugging
    • Basic Network Services I
    • Basic Network Services II
    • Basic Router Configuration
    • Basic Show Commands
    • Cisco Discovery Protocol
    • Cisco Discovery Protocol on a Router
    • Configuring DNS I
    • Configuring IPv6 I
    • Configuring IPv6 II
    • Configuring Network Address Translation I
    • Configuring Network Address Translation II
    • Configuring NTP Authentication I
    • Configuring NTP Authentication II
    • Configuring NTP I
    • Configuring NTP II
    • Configuring PPP-PAP-CHAP
    • Configuring Router Interfaces
    • Configuring Single-Area OSPFv3
    • Configuring Static and OSPFv3 Routing
    • Configuring Trunking
    • Configuring VLANs
    • Creating a Host Table
    • Default Routes
    • Deleting VLANs
    • DHCP
    • DHCP II
    • DHCP Relay Agents I
    • DHCP Relay Agents II
    • Dynamic NAT
    • Enhancing Switch Security I
    • Enhancing Switch Security II
    • Extended Access Lists
    • Frame Relay Hub-and-Spoke
    • Frame Relay I
    • IGRP
    • IGRP Routes
    • Initial Switch Configuration
    • IP Addressing on a Router
    • IP Addressing on a Switch
    • Loopback Interfaces
    • Many-to-One NAT
    • Named Extended Access Lists
    • NAT Overloading - PAT
    • NAT Pool
    • Numbered Access Lists
    • OSPF I
    • OSPF II
    • RIP Routes
    • RIPv2
    • RIPv2 Routes
    • Router Basics I
    • Router Basics II
    • Router Remote Access via Telnet
    • Routing Information Protocol I
    • Saving Router Configurations
    • Setting up a Serial Interface
    • Standard Access Lists
    • Static NAT I
    • Static NAT II
    • Static Routes I
    • Static Routes II
    • Switch and Workstation Configuration
    • Switch Basics I
    • Switch Basics II
    • Switch Remote Access via Telnet
    • Telnet I
    • Telnet II
    • Testing Connectivity with Traceroute
    • Trivial File Transfer Protocol
    • Troubleshooting a Network Topology
    • Troubleshooting DHCP
    • Troubleshooting DNS I
    • Troubleshooting DNS II
    • Troubleshooting Network Configuration
    • Troubleshooting NTP
    • Troubleshooting PPP-PAP-CHAP
    • Troubleshooting RIP
    • Troubleshooting VLSM
    • Using the System Configuration Dialog for Initial Switch Configurations
    • VLSM Practice I-D
    • VLSM Practice II-D
    • VLSM Practice III-D
    • VLSM Practice III-M
    • VLSM Practice II-M
    • VLSM Practice I-M